2018–2021 Jeep Grand Cherokee Wheel & Tire Fitment Guide
WK2 generation, Trackhawk. 5x127 bolt pattern, stock 20×10 ET50 on 295/45R20. Compare 3 popular upgrades or try your own size.
Specs
| Bolt pattern | 5x127 |
|---|---|
| Center bore | 71.5 mm |
| Lug thread | M14x1.5 |
| Reference trim | Trackhawk |
| Stock wheel | 20×10 ET50 |
| Stock tire | 295/45R20 |
| Stock overall diameter | 30.45 in |
Calculator
Starts on the stock setup. Drag the sliders or load one of the popular upgrades below.
The small mark on each slider shows the current value. Type in the box for sizes outside the slider range.
Custom vehicle measurementsOptional
Measure with your current wheels on the car and the results below show how much room the new setup leaves. The drawings use your numbers too. Leave blank anything you haven't measured.
- Park on level ground at normal ride height, wheels straight.
- Front and rear differ. Measure the axle you're changing, or enter the tighter corner.
Millimetres or centimetres are recommended: small gaps are easier to read accurately than inch marks.
Narrowest gap between the inside of the tire (or wheel, whichever sits further in) and the strut, spring perch or upper control arm. Wheels pointed straight.
Hang a plumb line or hold a straightedge vertically from the fender lip above the hub, then measure across to the outermost point of the tire or wheel. Enter a negative number if it already sticks out.
Straight up from the top of the tire to the fender lip, with the car on the ground at normal ride height.
Smallest gap between the outer edge of the brake caliper and the inside of the wheel barrel.
- Poke
- 0mm
- Wheel face stays where it is.
- Inner clearance
- 0mm
- Same room to the suspension.
- Overall diameter
- 0%
- 0 in, within ±3%.
- Speedo reads 60
- 60mph
- Your actual speed.
| Vehicle | Jeep Grand Cherokee Trackhawk | ||
|---|---|---|---|
| Bolt pattern | 5x127 | Hub bore | 71.5 mm |
| Current | 20×10 ET50, 295/45R20 | New | 20×10 ET50, 295/45R20 |
Popular upgrades
Each size compared with the stock 20×10 ET50, 295/45R20.
| Setup | Poke | Inner clearance | Diameter | Speedo reads 60 | Action |
|---|---|---|---|---|---|
| 20×10.5 stock height20×10.5 ET34, 295/45R20 | +22.3 mm | +9.7 mm | 0% | 60 mph | |
| 22×10 street22×10 ET35, 285/35R22 | +15 mm | +15 mm | −2% | 58.8 mph | |
| Drag front 20×10.520×10.5 ET38, 275/45R20 | +18.3 mm | +5.7 mm | −2.3% | 58.6 mph |
Shop this setup
I may earn a commission from links on this page.
Searches use the new setup above. Check the bolt pattern, offset and center bore on each listing before you buy, and use hub-centric rings if the wheel's bore is larger than your hub.
Notes
- Square setup: 20x10 +50 with 295/45ZR20 at all four corners.
- Trackhawk front Brembo 6-piston calipers on 400 mm rotors need 20 in wheels minimum, and some wheels that clear the SRT need spacers to clear the Trackhawk.
- Drag builds keep 20 in fronts and run 17x10 beadlock rears (+38) with 315/50R17 drag radials, because the rear calipers clear 17 in.
- Uses lug nuts on M14x1.5 studs with a 71.5 mm bore, shared with the WK2 SRT and Durango SRT.
Questions
What bolt pattern does a 2018–2021 Jeep Grand Cherokee use?
The 2018–2021 Jeep Grand Cherokee uses a 5x127 bolt pattern with a 71.5 mm center bore and M14x1.5 lug threads.
What size wheels and tires are stock on the 2018–2021 Jeep Grand Cherokee Trackhawk?
The 2018–2021 Jeep Grand Cherokee Trackhawk came with 20×10 ET50 wheels and 295/45R20 tires, about 30.5 inches in overall diameter.
How far does a 20×10.5 ET34 wheel stick out on a 2018–2021 Jeep Grand Cherokee?
On the 2018–2021 Jeep Grand Cherokee, compared with the stock 20×10 ET50, a 20×10.5 ET34 sits 22.3 mm further out at the outer lip and 9.7 mm further from the suspension at the inner barrel.
Which 2018–2021 Jeep Grand Cherokee wheel and tire upgrade keeps the speedometer most accurate?
Of the 2018–2021 Jeep Grand Cherokee upgrades listed here, 20×10.5 ET34 · 295/45R20 is closest to the stock 295/45R20, changing overall diameter by 0%. At an indicated 60 mph you would actually be doing 60 mph.
Do aftermarket wheels need hub-centric rings on a 2018–2021 Jeep Grand Cherokee?
The 2018–2021 Jeep Grand Cherokee's hub bore is 71.5 mm. Wheels machined to exactly 71.5 mm center on the hub directly; wheels with a larger bore need 71.5 mm hub-centric rings to avoid vibration.
Also on 5x127
These share the bolt pattern. Check offset, hub bore and brake clearance before swapping wheels.
| Vehicle | Generation | Bolt pattern | Hub bore |
|---|---|---|---|
| 2020+ Jeep Gladiator | JT | 5x127 | 71.5 mm |
| 2018+ Jeep Wrangler | JL | 5x127 | 71.5 mm |
| 2007–2018 Jeep Wrangler | JK | 5x127 | 71.5 mm |