1998–2002 Pontiac Firebird Wheel & Tire Fitment Guide
4th gen generation, Trans Am WS6. 5x120.65 bolt pattern, stock 17×9 ET50 on 275/40R17. Compare 2 popular upgrades or try your own size.
Specs
| Bolt pattern | 5x120.65 |
|---|---|
| Center bore | 70.3 mm |
| Lug thread | M12x1.5 |
| Reference trim | Trans Am WS6 |
| Stock wheel | 17×9 ET50 |
| Stock tire | 275/40R17 |
| Stock overall diameter | 25.66 in |
Calculator
Starts on the stock setup. Drag the sliders or load one of the popular upgrades below.
The small mark on each slider shows the current value. Type in the box for sizes outside the slider range.
Custom vehicle measurementsOptional
Measure with your current wheels on the car and the results below show how much room the new setup leaves. The drawings use your numbers too. Leave blank anything you haven't measured.
- Park on level ground at normal ride height, wheels straight.
- Front and rear differ. Measure the axle you're changing, or enter the tighter corner.
Millimetres or centimetres are recommended: small gaps are easier to read accurately than inch marks.
Narrowest gap between the inside of the tire (or wheel, whichever sits further in) and the strut, spring perch or upper control arm. Wheels pointed straight.
Hang a plumb line or hold a straightedge vertically from the fender lip above the hub, then measure across to the outermost point of the tire or wheel. Enter a negative number if it already sticks out.
Straight up from the top of the tire to the fender lip, with the car on the ground at normal ride height.
Smallest gap between the outer edge of the brake caliper and the inside of the wheel barrel.
- Poke
- 0mm
- Wheel face stays where it is.
- Inner clearance
- 0mm
- Same room to the suspension.
- Overall diameter
- 0%
- 0 in, within ±3%.
- Speedo reads 60
- 60mph
- Your actual speed.
| Vehicle | Pontiac Firebird Trans Am WS6 | ||
|---|---|---|---|
| Bolt pattern | 5x120.65 | Hub bore | 70.3 mm |
| Current | 17×9 ET50, 275/40R17 | New | 17×9 ET50, 275/40R17 |
Popular upgrades
Each size compared with the stock 17×9 ET50, 275/40R17.
| Setup | Poke | Inner clearance | Diameter | Speedo reads 60 | Action |
|---|---|---|---|---|---|
| ZR1-style 17×9.517×9.5 ET56, 275/40R17 | +0.3 mm | −12.3 mm | 0% | 60 mph | |
| Z06-style 18×9.518×9.5 ET56, 275/35R18 | +0.3 mm | −12.3 mm | −0.3% | 59.8 mph |
Shop this setup
I may earn a commission from links on this page.
Searches use the new setup above. Check the bolt pattern, offset and center bore on each listing before you buy, and use hub-centric rings if the wheel's bore is larger than your hub.
Notes
- Square setup: 17×9 ET50 with P275/40ZR17 at all four corners.
- On 18×9.5 wheels owners report 275/35R18 clears up front, while 275/40R18 rubs slightly in hard turns.
- Owners caution that 285s up front need care on any wheel with less offset than the stock 50 mm.
- Lug nuts are M12×1.5 on a 70.3 mm hub.
Questions
What bolt pattern does a 1998–2002 Pontiac Firebird use?
The 1998–2002 Pontiac Firebird uses a 5x120.65 bolt pattern with a 70.3 mm center bore and M12x1.5 lug threads.
What size wheels and tires are stock on the 1998–2002 Pontiac Firebird Trans Am WS6?
The 1998–2002 Pontiac Firebird Trans Am WS6 came with 17×9 ET50 wheels and 275/40R17 tires, about 25.7 inches in overall diameter.
How far does a 17×9.5 ET56 wheel stick out on a 1998–2002 Pontiac Firebird?
On the 1998–2002 Pontiac Firebird, compared with the stock 17×9 ET50, a 17×9.5 ET56 sits 0.3 mm further out at the outer lip and 12.3 mm closer to the suspension at the inner barrel.
Which 1998–2002 Pontiac Firebird wheel and tire upgrade keeps the speedometer most accurate?
Of the 1998–2002 Pontiac Firebird upgrades listed here, 17×9.5 ET56 · 275/40R17 is closest to the stock 275/40R17, changing overall diameter by 0%. At an indicated 60 mph you would actually be doing 60 mph.
Do aftermarket wheels need hub-centric rings on a 1998–2002 Pontiac Firebird?
The 1998–2002 Pontiac Firebird's hub bore is 70.3 mm. Wheels machined to exactly 70.3 mm center on the hub directly; wheels with a larger bore need 70.3 mm hub-centric rings to avoid vibration.
Also on 5x120.65
These share the bolt pattern. Check offset, hub bore and brake clearance before swapping wheels.
| Vehicle | Generation | Bolt pattern | Hub bore |
|---|---|---|---|
| 2001–2004 Chevrolet Corvette | C5 | 5x120.65 | 70.3 mm |
| 2005–2013 Chevrolet Corvette | C6 | 5x120.65 | 70.3 mm |
| 2014–2019 Chevrolet Corvette | C7 | 5x120.65 | 70.3 mm |