2015–2025 Lexus RC F Wheel & Tire Fitment Guide
USC10 generation, base. 5x114.3 bolt pattern, stock 19×9 ET50 on 255/35R19. Compare 3 popular upgrades or try your own size.
Specs
| Bolt pattern | 5x114.3 |
|---|---|
| Center bore | 60.1 mm |
| Lug thread | M12x1.5 |
| Reference trim | base |
| Stock wheel | 19×9 ET50 |
| Stock tire | 255/35R19 |
| Stock overall diameter | 26.03 in |
Calculator
Starts on the stock setup. Drag the sliders or load one of the popular upgrades below.
The small mark on each slider shows the current value. Type in the box for sizes outside the slider range.
Custom vehicle measurementsOptional
Measure with your current wheels on the car and the results below show how much room the new setup leaves. The drawings use your numbers too. Leave blank anything you haven't measured.
- Park on level ground at normal ride height, wheels straight.
- Front and rear differ. Measure the axle you're changing, or enter the tighter corner.
Millimetres or centimetres are recommended: small gaps are easier to read accurately than inch marks.
Narrowest gap between the inside of the tire (or wheel, whichever sits further in) and the strut, spring perch or upper control arm. Wheels pointed straight.
Hang a plumb line or hold a straightedge vertically from the fender lip above the hub, then measure across to the outermost point of the tire or wheel. Enter a negative number if it already sticks out.
Straight up from the top of the tire to the fender lip, with the car on the ground at normal ride height.
Smallest gap between the outer edge of the brake caliper and the inside of the wheel barrel.
- Poke
- 0mm
- Wheel face stays where it is.
- Inner clearance
- 0mm
- Same room to the suspension.
- Overall diameter
- 0%
- 0 in, within ±3%.
- Speedo reads 60
- 60mph
- Your actual speed.
| Vehicle | Lexus RC F base | ||
|---|---|---|---|
| Bolt pattern | 5x114.3 | Hub bore | 60.1 mm |
| Current | 19×9 ET50, 255/35R19 | New | 19×9 ET50, 255/35R19 |
Popular upgrades
Each size compared with the stock 19×9 ET50, 255/35R19.
| Setup | Poke | Inner clearance | Diameter | Speedo reads 60 | Action |
|---|---|---|---|---|---|
| Stock + 20mm spacer19×9 ET30, 255/35R19 | +20 mm | +20 mm | 0% | 60 mph | |
| TE37 19×9.519×9.5 ET35, 255/35R19 | +21.3 mm | +8.7 mm | 0% | 60 mph | |
| Square Advan GT 19×1019×10 ET35, 275/35R19 | +27.7 mm | +2.3 mm | +2.1% | 61.3 mph |
Shop this setup
I may earn a commission from links on this page.
Searches use the new setup above. Check the bolt pattern, offset and center bore on each listing before you buy, and use hub-centric rings if the wheel's bore is larger than your hub.
Notes
- Staggered from the factory. Rear stock: 19×10 ET41 with 275/35R19. All three OEM BBS wheel designs share these sizes.
- The front Brembo 6-piston calipers rule out most 18s. Enkei RPF1 18s do not clear, and only forged 18s built for big-caliper clearance fit.
- A square 19×10 +35 with 275/35 sits flush; lowered cars rub the front slightly at times. 19×9.5 +35 on Swift springs rubs at full lock with the stock 255/35 tire.
- Lug nuts are M12x1.5 with a 21 mm hex.
Questions
What bolt pattern does a 2015–2025 Lexus RC F use?
The 2015–2025 Lexus RC F uses a 5x114.3 bolt pattern with a 60.1 mm center bore and M12x1.5 lug threads.
What size wheels and tires are stock on the 2015–2025 Lexus RC F base?
The 2015–2025 Lexus RC F base came with 19×9 ET50 wheels and 255/35R19 tires, about 26 inches in overall diameter.
How far does a 19×10 ET35 wheel stick out on a 2015–2025 Lexus RC F?
On the 2015–2025 Lexus RC F, compared with the stock 19×9 ET50, a 19×10 ET35 sits 27.7 mm further out at the outer lip and 2.3 mm further from the suspension at the inner barrel.
Which 2015–2025 Lexus RC F wheel and tire upgrade keeps the speedometer most accurate?
Of the 2015–2025 Lexus RC F upgrades listed here, 19×9 ET30 · 255/35R19 is closest to the stock 255/35R19, changing overall diameter by 0%. At an indicated 60 mph you would actually be doing 60 mph.
Do aftermarket wheels need hub-centric rings on a 2015–2025 Lexus RC F?
The 2015–2025 Lexus RC F's hub bore is 60.1 mm. Wheels machined to exactly 60.1 mm center on the hub directly; wheels with a larger bore need 60.1 mm hub-centric rings to avoid vibration.
Also on 5x114.3
These share the bolt pattern. Check offset, hub bore and brake clearance before swapping wheels.
| Vehicle | Generation | Bolt pattern | Hub bore |
|---|---|---|---|
| 2001–2005 Lexus IS 300 | XE10 | 5x114.3 | 60.1 mm |
| 2023+ Toyota GR Corolla | E210 | 5x114.3 | 60.1 mm |
| 1993–1998 Toyota Supra | A80 (MK4) | 5x114.3 | 60.1 mm |
| 2002–2006 Acura RSX | DC5 | 5x114.3 | 64.1 mm |
| 2009–2014 Acura TSX | CU2 | 5x114.3 | 64.1 mm |
| 2019+ Genesis G70 | 1st gen (IK) | 5x114.3 | 67.1 mm |