2012–2013 Volkswagen Golf R Wheel & Tire Fitment Guide
Mk6 generation, Base. 5x112 bolt pattern, stock 18×7.5 ET51 on 225/40R18. Compare 2 popular upgrades or try your own size.
Specs
| Bolt pattern | 5x112 |
|---|---|
| Center bore | 57.1 mm |
| Lug thread | M14x1.5 |
| Reference trim | Base |
| Stock wheel | 18×7.5 ET51 |
| Stock tire | 225/40R18 |
| Stock overall diameter | 25.09 in |
Calculator
Starts on the stock setup. Drag the sliders or load one of the popular upgrades below.
The small mark on each slider shows the current value. Type in the box for sizes outside the slider range.
Custom vehicle measurementsOptional
Measure with your current wheels on the car and the results below show how much room the new setup leaves. The drawings use your numbers too. Leave blank anything you haven't measured.
- Park on level ground at normal ride height, wheels straight.
- Front and rear differ. Measure the axle you're changing, or enter the tighter corner.
Millimetres or centimetres are recommended: small gaps are easier to read accurately than inch marks.
Narrowest gap between the inside of the tire (or wheel, whichever sits further in) and the strut, spring perch or upper control arm. Wheels pointed straight.
Hang a plumb line or hold a straightedge vertically from the fender lip above the hub, then measure across to the outermost point of the tire or wheel. Enter a negative number if it already sticks out.
Straight up from the top of the tire to the fender lip, with the car on the ground at normal ride height.
Smallest gap between the outer edge of the brake caliper and the inside of the wheel barrel.
- Poke
- 0mm
- Wheel face stays where it is.
- Inner clearance
- 0mm
- Same room to the suspension.
- Overall diameter
- 0%
- 0 in, within ±3%.
- Speedo reads 60
- 60mph
- Your actual speed.
| Vehicle | Volkswagen Golf R Base | ||
|---|---|---|---|
| Bolt pattern | 5x112 | Hub bore | 57.1 mm |
| Current | 18×7.5 ET51, 225/40R18 | New | 18×7.5 ET51, 225/40R18 |
Popular upgrades
Each size compared with the stock 18×7.5 ET51, 225/40R18.
| Setup | Poke | Inner clearance | Diameter | Speedo reads 60 | Action |
|---|---|---|---|---|---|
| Flush 18×8.518×8.5 ET45, 235/40R18 | +18.7 mm | −6.7 mm | +1.3% | 60.8 mph | |
| Track square 17×8.517×8.5 ET43, 235/45R17 | +20.7 mm | −4.7 mm | +1% | 60.6 mph |
Shop this setup
I may earn a commission from links on this page.
Searches use the new setup above. Check the bolt pattern, offset and center bore on each listing before you buy, and use hub-centric rings if the wheel's bore is larger than your hub.
Notes
- The stock 18×7.5 ET51 wheel is the same size as the Mk6 GTI's optional 18s, on 225/40R18.
- The Golf R has larger front brakes than the GTI; Apex says its 17×8.5 ET43 wheels clear them, but check caliper clearance on other 17" designs.
- On this AWD car, keep a square setup. 18×8.5 at ET42-45 sits flush, while offsets below about ET40 tend to rub the fenders, and lowered cars should watch the front liners at full lock.
- Uses M14x1.5 ball-seat lug bolts.
Questions
What bolt pattern does a 2012–2013 Volkswagen Golf R use?
The 2012–2013 Volkswagen Golf R uses a 5x112 bolt pattern with a 57.1 mm center bore and M14x1.5 lug threads.
What size wheels and tires are stock on the 2012–2013 Volkswagen Golf R Base?
The 2012–2013 Volkswagen Golf R Base came with 18×7.5 ET51 wheels and 225/40R18 tires, about 25.1 inches in overall diameter.
How far does a 17×8.5 ET43 wheel stick out on a 2012–2013 Volkswagen Golf R?
On the 2012–2013 Volkswagen Golf R, compared with the stock 18×7.5 ET51, a 17×8.5 ET43 sits 20.7 mm further out at the outer lip and 4.7 mm closer to the suspension at the inner barrel.
Which 2012–2013 Volkswagen Golf R wheel and tire upgrade keeps the speedometer most accurate?
Of the 2012–2013 Volkswagen Golf R upgrades listed here, 17×8.5 ET43 · 235/45R17 is closest to the stock 225/40R18, changing overall diameter by +1%. At an indicated 60 mph you would actually be doing 60.6 mph.
Do aftermarket wheels need hub-centric rings on a 2012–2013 Volkswagen Golf R?
The 2012–2013 Volkswagen Golf R's hub bore is 57.1 mm. Wheels machined to exactly 57.1 mm center on the hub directly; wheels with a larger bore need 57.1 mm hub-centric rings to avoid vibration.
Also on 5x112
These share the bolt pattern. Check offset, hub bore and brake clearance before swapping wheels.
| Vehicle | Generation | Bolt pattern | Hub bore |
|---|---|---|---|
| 2015–2021 Volkswagen Golf GTI | Mk7/Mk7.5 | 5x112 | 57.1 mm |
| 2022+ Volkswagen Golf GTI | Mk8 | 5x112 | 57.1 mm |
| 2015–2019 Volkswagen Golf R | Mk7/Mk7.5 | 5x112 | 57.1 mm |
| 2022+ Volkswagen Golf R | Mk8 | 5x112 | 57.1 mm |
| 2006–2009 Volkswagen GTI | Mk5 | 5x112 | 57.1 mm |
| 2019+ Volkswagen Jetta GLI | Mk7 | 5x112 | 57.1 mm |