2006–2009 Volkswagen GTI Wheel & Tire Fitment Guide
Mk5 generation, Base. 5x112 bolt pattern, stock 17×7.5 ET51 on 225/45R17. Compare 3 popular upgrades or try your own size.
Specs
| Bolt pattern | 5x112 |
|---|---|
| Center bore | 57.1 mm |
| Lug thread | M14x1.5 |
| Reference trim | Base |
| Stock wheel | 17×7.5 ET51 |
| Stock tire | 225/45R17 |
| Stock overall diameter | 24.97 in |
Calculator
Starts on the stock setup. Drag the sliders or load one of the popular upgrades below.
The small mark on each slider shows the current value. Type in the box for sizes outside the slider range.
Custom vehicle measurementsOptional
Measure with your current wheels on the car and the results below show how much room the new setup leaves. The drawings use your numbers too. Leave blank anything you haven't measured.
- Park on level ground at normal ride height, wheels straight.
- Front and rear differ. Measure the axle you're changing, or enter the tighter corner.
Millimetres or centimetres are recommended: small gaps are easier to read accurately than inch marks.
Narrowest gap between the inside of the tire (or wheel, whichever sits further in) and the strut, spring perch or upper control arm. Wheels pointed straight.
Hang a plumb line or hold a straightedge vertically from the fender lip above the hub, then measure across to the outermost point of the tire or wheel. Enter a negative number if it already sticks out.
Straight up from the top of the tire to the fender lip, with the car on the ground at normal ride height.
Smallest gap between the outer edge of the brake caliper and the inside of the wheel barrel.
- Poke
- 0mm
- Wheel face stays where it is.
- Inner clearance
- 0mm
- Same room to the suspension.
- Overall diameter
- 0%
- 0 in, within ±3%.
- Speedo reads 60
- 60mph
- Your actual speed.
| Vehicle | Volkswagen GTI Base | ||
|---|---|---|---|
| Bolt pattern | 5x112 | Hub bore | 57.1 mm |
| Current | 17×7.5 ET51, 225/45R17 | New | 17×7.5 ET51, 225/45R17 |
Popular upgrades
Each size compared with the stock 17×7.5 ET51, 225/45R17.
| Setup | Poke | Inner clearance | Diameter | Speedo reads 60 | Action |
|---|---|---|---|---|---|
| OEM+ 18×7.518×7.5 ET51, 225/40R18 | 0 mm | 0 mm | +0.5% | 60.3 mph | |
| Popular 18×8.518×8.5 ET43, 225/40R18 | +20.7 mm | −4.7 mm | +0.5% | 60.3 mph | |
| Flush lowered 18×8.518×8.5 ET40, 225/40R18 | +23.7 mm | −1.7 mm | +0.5% | 60.3 mph |
Shop this setup
I may earn a commission from links on this page.
Searches use the new setup above. Check the bolt pattern, offset and center bore on each listing before you buy, and use hub-centric rings if the wheel's bore is larger than your hub.
Notes
- The stock 17" wheel is the Denver (7.5J ET51); the factory 18" option is 7.5J ET51 on 225/40R18.
- Uses M14x1.5 lug bolts with a ball (radius) seat; most aftermarket wheels need cone-seat bolts.
- On a lowered car 18×8.5 ET40 with 225/40R18 clears the liners; offsets below about ET35 need fender rolling and tend to rub.
- The 5x112 / 57.1 mm hub carries over to the Mk6 and Mk7 GTI, so OEM wheels from those cars bolt on.
Questions
What bolt pattern does a 2006–2009 Volkswagen GTI use?
The 2006–2009 Volkswagen GTI uses a 5x112 bolt pattern with a 57.1 mm center bore and M14x1.5 lug threads.
What size wheels and tires are stock on the 2006–2009 Volkswagen GTI Base?
The 2006–2009 Volkswagen GTI Base came with 17×7.5 ET51 wheels and 225/45R17 tires, about 25 inches in overall diameter.
How far does a 18×8.5 ET40 wheel stick out on a 2006–2009 Volkswagen GTI?
On the 2006–2009 Volkswagen GTI, compared with the stock 17×7.5 ET51, a 18×8.5 ET40 sits 23.7 mm further out at the outer lip and 1.7 mm closer to the suspension at the inner barrel.
Which 2006–2009 Volkswagen GTI wheel and tire upgrade keeps the speedometer most accurate?
Of the 2006–2009 Volkswagen GTI upgrades listed here, 18×7.5 ET51 · 225/40R18 is closest to the stock 225/45R17, changing overall diameter by +0.5%. At an indicated 60 mph you would actually be doing 60.3 mph.
Do aftermarket wheels need hub-centric rings on a 2006–2009 Volkswagen GTI?
The 2006–2009 Volkswagen GTI's hub bore is 57.1 mm. Wheels machined to exactly 57.1 mm center on the hub directly; wheels with a larger bore need 57.1 mm hub-centric rings to avoid vibration.
Also on 5x112
These share the bolt pattern. Check offset, hub bore and brake clearance before swapping wheels.
| Vehicle | Generation | Bolt pattern | Hub bore |
|---|---|---|---|
| 2015–2021 Volkswagen Golf GTI | Mk7/Mk7.5 | 5x112 | 57.1 mm |
| 2022+ Volkswagen Golf GTI | Mk8 | 5x112 | 57.1 mm |
| 2012–2013 Volkswagen Golf R | Mk6 | 5x112 | 57.1 mm |
| 2015–2019 Volkswagen Golf R | Mk7/Mk7.5 | 5x112 | 57.1 mm |
| 2022+ Volkswagen Golf R | Mk8 | 5x112 | 57.1 mm |
| 2019+ Volkswagen Jetta GLI | Mk7 | 5x112 | 57.1 mm |