2019+ Volkswagen Jetta GLI Wheel & Tire Fitment Guide
Mk7 generation, Autobahn. 5x112 bolt pattern, stock 18×7.5 ET49 on 225/45R18. Compare 2 popular upgrades or try your own size.
Specs
| Bolt pattern | 5x112 |
|---|---|
| Center bore | 57.1 mm |
| Lug thread | M14x1.5 |
| Reference trim | Autobahn |
| Stock wheel | 18×7.5 ET49 |
| Stock tire | 225/45R18 |
| Stock overall diameter | 25.97 in |
Calculator
Starts on the stock setup. Drag the sliders or load one of the popular upgrades below.
The small mark on each slider shows the current value. Type in the box for sizes outside the slider range.
Custom vehicle measurementsOptional
Measure with your current wheels on the car and the results below show how much room the new setup leaves. The drawings use your numbers too. Leave blank anything you haven't measured.
- Park on level ground at normal ride height, wheels straight.
- Front and rear differ. Measure the axle you're changing, or enter the tighter corner.
Millimetres or centimetres are recommended: small gaps are easier to read accurately than inch marks.
Narrowest gap between the inside of the tire (or wheel, whichever sits further in) and the strut, spring perch or upper control arm. Wheels pointed straight.
Hang a plumb line or hold a straightedge vertically from the fender lip above the hub, then measure across to the outermost point of the tire or wheel. Enter a negative number if it already sticks out.
Straight up from the top of the tire to the fender lip, with the car on the ground at normal ride height.
Smallest gap between the outer edge of the brake caliper and the inside of the wheel barrel.
- Poke
- 0mm
- Wheel face stays where it is.
- Inner clearance
- 0mm
- Same room to the suspension.
- Overall diameter
- 0%
- 0 in, within ±3%.
- Speedo reads 60
- 60mph
- Your actual speed.
| Vehicle | Volkswagen Jetta GLI Autobahn | ||
|---|---|---|---|
| Bolt pattern | 5x112 | Hub bore | 57.1 mm |
| Current | 18×7.5 ET49, 225/45R18 | New | 18×7.5 ET49, 225/45R18 |
Popular upgrades
Each size compared with the stock 18×7.5 ET49, 225/45R18.
| Setup | Poke | Inner clearance | Diameter | Speedo reads 60 | Action |
|---|---|---|---|---|---|
| OEM+ 18×8.518×8.5 ET43, 225/40R18 | +18.7 mm | −6.7 mm | −3.4% | 58 mph | |
| Lowered 19×8.519×8.5 ET43, 235/40R19 | +18.7 mm | −6.7 mm | +1.7% | 61 mph |
Shop this setup
I may earn a commission from links on this page.
Searches use the new setup above. Check the bolt pattern, offset and center bore on each listing before you buy, and use hub-centric rings if the wheel's bore is larger than your hub.
Notes
- Every GLI uses the 340 mm front rotors from the GTI Performance Pack, so 16-inch wheels won't fit. 17 inches is the minimum, and some spoke designs still hit the calipers.
- The factory 18×7.5 ET49 twin 5-spoke wheel (part 5GM601025AJ) is listed for 2019-2024 GLIs and wears 225/45R18 tires.
- The GLI shares 5x112 and the 57.1 mm hub with the Mk7/Mk8 GTI and Golf R, so wheels made for those cars fit with no hub rings.
- The car uses M14x1.5 lug bolts, not studs. VW's OEM bolts have a ball seat, and most aftermarket wheels need conical-seat bolts.
Questions
What bolt pattern does a 2019+ Volkswagen Jetta GLI use?
The 2019+ Volkswagen Jetta GLI uses a 5x112 bolt pattern with a 57.1 mm center bore and M14x1.5 lug threads.
What size wheels and tires are stock on the 2019+ Volkswagen Jetta GLI Autobahn?
The 2019+ Volkswagen Jetta GLI Autobahn came with 18×7.5 ET49 wheels and 225/45R18 tires, about 26 inches in overall diameter.
How far does a 18×8.5 ET43 wheel stick out on a 2019+ Volkswagen Jetta GLI?
On the 2019+ Volkswagen Jetta GLI, compared with the stock 18×7.5 ET49, a 18×8.5 ET43 sits 18.7 mm further out at the outer lip and 6.7 mm closer to the suspension at the inner barrel.
Which 2019+ Volkswagen Jetta GLI wheel and tire upgrade keeps the speedometer most accurate?
Of the 2019+ Volkswagen Jetta GLI upgrades listed here, 19×8.5 ET43 · 235/40R19 is closest to the stock 225/45R18, changing overall diameter by +1.7%. At an indicated 60 mph you would actually be doing 61 mph.
Do aftermarket wheels need hub-centric rings on a 2019+ Volkswagen Jetta GLI?
The 2019+ Volkswagen Jetta GLI's hub bore is 57.1 mm. Wheels machined to exactly 57.1 mm center on the hub directly; wheels with a larger bore need 57.1 mm hub-centric rings to avoid vibration.
Also on 5x112
These share the bolt pattern. Check offset, hub bore and brake clearance before swapping wheels.
| Vehicle | Generation | Bolt pattern | Hub bore |
|---|---|---|---|
| 2015–2021 Volkswagen Golf GTI | Mk7/Mk7.5 | 5x112 | 57.1 mm |
| 2022+ Volkswagen Golf GTI | Mk8 | 5x112 | 57.1 mm |
| 2012–2013 Volkswagen Golf R | Mk6 | 5x112 | 57.1 mm |
| 2015–2019 Volkswagen Golf R | Mk7/Mk7.5 | 5x112 | 57.1 mm |
| 2022+ Volkswagen Golf R | Mk8 | 5x112 | 57.1 mm |
| 2006–2009 Volkswagen GTI | Mk5 | 5x112 | 57.1 mm |